Monessen Hearth 3000 SERIES Instructions d'exploitation télécharger pdf (Page 40)

74D3000

BLDV7 Series Gas Fireplace





All System conguration/setup is done on the Command Center.

 When using On/Off wall switch, the switch must be in the ON position to perform all congura-

tion set ups at the command center.



1. Holding the ON button on the Command Center while turning on the master switch will toggle be-

tween standing pilot and intermittent pilot.

. After the above operation, one beep (for standing pilot) or two beeps (for intermittent pilot) will be

given as conrmation.



1. The system comes preset from the factory with a six (6) hour shutdown from its last command of

operation. This is done to prevent the replace from continuing to operate if unattended. You may

disable this feature if you wish.

 By disabling this feature, your replace may continue to operate unattended.

. When the master switch is in the ON position (“-”), pressing the ON button and the OFF button

on the Command Center simultaneously will toggle between enabling and disabling the six-hour

shutdown option.

3. After the above operation, one beep (for enabling the six-hour shutdown option) or two beeps (for

disabling the six-hour shutdown option) will be given as conrmation.



1. The RF receiver button located on the Control Board must be in the on position before the learn

function can begin. Use paper clip to depress button. One beep for RF receiver ON or two beeps

for RF receiver OFF will be given as conrmation. Refer to Figure 57 for location.

. After the RF receiver is on, holding the OFF button on the Command Center while turning on the

master switch will activate the learn function for the transmitter.

3. After the above operation, two beeps will be given and the green LED on the Command Center will

ash for 10 seconds.

4. During the 10 seconds, press the OFF button on a transmitter to learn. Another two beeps will be

given to conrm a successful learning. Refer to transmitter instructions for remote operations.



To shut off the standing pilot for service or summer shut down, press and hold the ON button on the

Command Center for 3 seconds when the master switch is in the ON position (“-”) and the main burner

is off.

: Pilot will resume the next time system is turned on.



When On/Off wall switch is used, it must be in the On position to perform all system setups.

  

Intermittent/Standing Hold the ON ▲ button while turning on the master switch Intermittent

Pilot Setup (Beep once for standing pilot, twice for intermittent pilot) Pilot

Standing Pilot Temp. Hold the ON ▲ button 3 seconds (when the master switch

Shutoff on the main burner is off)

RF Remote Receiver Push the RF receiver On/Off button on the control board RF OFF

On/Off Beep once for ON and beep twice for OFF

Learn Remote Hold the OFF ▼ button while turning on the master switch

Transmitter (Beep twice then press any handheld remote button)

6-hour safety Press the ON ▲ button and OFF ▼ button simultaneously ON

shutdown setup (Beep once for ON, twice for OFF)

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 59 60

Commentaires sur ces manuels

Pas de commentaire

Monessen Hearth 3000 SERIES Instructions d'exploitation Page 40

Commentaires sur ces manuels

Produits connexes et manuels pour Foyers Monessen Hearth 3000 SERIES