Monessen Hearth DFS42PVC Instructions d'exploitation télécharger pdf (Page 18)

18 71D0532

CHECKING GAS PRESSURE

MILLI-VOLT CONTROL (Figure 16)

The valve regulator controls the burner pressure which

should be checked at the pressure test point.

Turn captured screw counter clockwise two or three

turns and then place tubing to pressure gauge over

test point (Use test point “OUT” closest to control

knob). After taking pressure reading, be sure and turn

captured screw clockwise firmly to re-seal. Do not

over torque. Check for gas leaks.

Figure 16 - Pressure Test Point Location

Milli-Volt Control

When tightening up the joint to the valve, hold the valve securely to prevent movement.

Test all gas joints from the gas meter to the heater valve for leaks using a gas analyzer or soap and water solution after

completing connection. DO NOT USE AN OPEN FLAME.

Check the gas pressure with the appliance burning and the control set to HIGH.

Connecting directly to an

unregulated propane/LPG tank

can cause an explosion.

WARNING

Test Port “OUT”

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

Pas de commentaire

Monessen Hearth DFS42PVC Instructions d'exploitation Page 18